By pulling on the screwdriver shaft, stretch the spring so you can fit one of the coins between the two spring coils nearest the short end.
Put a screwdriver shaft through the short end of the spring so that you can hold it with two fingers on the shaft either side of the hook.
Hook the long end of the spring over something secure (I was able to hook it over one of the jaws of a bench vice).
The coins and flat bar are used to stretch the spring.
Two torches, one of these being a slim head torch.
A 60mm length of flat brass or steel bar, approx 10 x 2mm or thicker (I used an offcut of a 1m length I got ages ago from B&Q - product code.
Screwdriver (type not important, just using the shaft).
(Ignore the plastic pivot(?) piece that comes with it.)
A new spring, obtainable from your Ford dealer or eBay.
I ended up using a variation of this method, as describedīelow, which would enable me to replace another one quite quickly. Here about how it could be made 'easier' by stretching the spring with coins before trying to fit it. I done a bit of reading on various websites Replacing a broken clutch pedal return spring on a Ford Focus is a bit of a pig of a job. Replacing Clutch Pedal Return Spring on Ford Focus Note: the Programmer draws around 230mA from the USB portĬan exhibit strange or inconsistent behaviour if connected to a USB port thatĬannot provide enough power. Occasionally have to uninstall it and repeat the procedure above to re-install You may find that Windows periodically disables the driver, so you might
Run the G540 software and verify that the Programmer works correctly.
#HOW TO RUN EPROM PROGRAMMER ON WINDOWS 10 INSTALL#
Wait for Windows to install the driver files (which may take several minutes).
When Windows has rebooted, connect the programmer to a USB port, and.
#HOW TO RUN EPROM PROGRAMMER ON WINDOWS 10 DRIVERS#
When the drivers have installed, reboot to re-enable driver signature enforcement.
A Windows Securityĭialog will be displayed during the process - click "Install this driver
When Windows has rebooted, install the USB drivers in the normal way.
When the Start-up Settings screen is displayed, press the key to.
When the Choose An Option screen is displayed, click Troubleshoot, thenĪdvanced Options, then Start-up Settings, then Restart.
Under Advanced Start-up, click Restart Now.
#HOW TO RUN EPROM PROGRAMMER ON WINDOWS 10 UPDATE#
Click Update & Security, then Recovery.
Click the Start menu and select Settings.
Make sure that all your work is closed.
The following instructions as you won't be able to read them after step 4): To get round this, you need to temporarily disable Windows 10 driver signatureĮnforcement, then install the USB drivers. The problem is that the USB drivers are not signed. Install the USB driver package (StglCproUSB_Installer.exe). Should install correctly but you will probably get an error when you try to Programmer on Windows 10, the main software package (G540EngSetup.exe) Replacing Clutch Pedal Return Spring on Ford Focus Genius G540 EPROM Programmer - Installing on Windows 10 Genius G540 EPROM Programmer - Installing on Windows 10